Gotham Incito DMX512_RDM Field Rev. E Manual do Utilizador descarregar pdf (Página 4)

Protocols Supported

The DMXR module supports the current DMX standard ANSI E1.11 DMX512-A and is backwards

compatible to USITT DMX512 (1990). Also supported is ANSI E1.20 RDM (Remote Device

Management).

Installation

Default Settings Table

Network Setup

• Use the pinout configuration on page 6 to connect to the lighting controller.

• Including the DMX512 source, a maximum of 32 Incitos per LAN is allowed. Consult factory

DMX Address 001

DMX Channel 1-DMX Slot (8-bit level)

RDM Personality Linear Curve

Incito Driver

Logarithmic curve (Overall

fixture response will be

logarithmic)

Loss of DMX Signal Hold last level forever

Default DMX/ RDM Settings

for applications requiring more than 32 Incitos per LAN. Note: One universe fed into an opto-

splitter creates multiple LANs. See Figure 2

• Using the appropriate category cable, daisy chain between luminaires and back to the control

system. Note: No T-TAPS, STARS (except by an opto-splitter) or Ys allowed.

• A termination plug is included with each luminaire. Ensure the termination plug is installed into

the last luminaire in the daisy chain. If this component is not installed the luminaires will exhibit

erratic/intermittent behavior.

• 2000 feet is the maximum distance to the furthest luminaire.

CJ520003 Rev. E

4 of 11

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

Gotham Incito DMX512_RDM Field Rev. E Manual do Utilizador Página 4